Zebra プリンター設定生成
一般的な Zebra プリンター設定用の ZPL / SGD スニペットを作成します。実機で試す前に、幅、長さ、濃度、速度、向き、メディア関連コマンドを生成できます。
^PW^LL~SD^PR
プリンター設定
ZPL / SGDSend settings only to printers you control. Test on non-production media first because darkness, speed and calibration affect real labels.
生成されたコマンド
Device setupProduction safety note
These commands may change physical printer behavior. Verify values against your printer model, media and ribbon before using in production.
Generate printer settings in three steps
Enter label and printer values
Set width, length, darkness, speed, orientation and media type for your Zebra printer.
Generate setup commands
The tool outputs common ZPL and SGD commands that can be sent to controlled devices.
Test on real hardware
Print a configuration label or test media before rolling settings into production workflows.
よくある質問
~SD controls print darkness. Higher values print darker, but too much darkness can reduce barcode quality.
^PW sets print width in dots. Match it to your label width and printer DPI.
No. This page generates commands only. Copy them into your trusted printing workflow or device management tool.
The output includes a common SGD print-method command alongside ZPL commands where useful.