Zebra Printer Settings Generator

Create ZPL and SGD snippets for common Zebra printer configuration tasks. Generate width, length, darkness, speed, orientation and media commands before testing on the real device.

^PW^LL~SD^PR

Printer settings

ZPL / SGD

Print width dots (^PW)

Label length dots (^LL)

Darkness 0-30 (~SD)

Print speed (^PR)

Orientation

Media type

Print configuration label (~WC)Run media calibration (~JC)

Send settings only to printers you control. Test on non-production media first because darkness, speed and calibration affect real labels.

Generated commands

Device setup

Width812

Darkness15

Speed4

ZPL / SGD command output

^XA
^PW812
^LL1218
~SD15
^PR4
^PON
! U1 setvar "ezpl.print_method" "t"
~WC
^XZ

Production safety note

These commands may change physical printer behavior. Verify values against your printer model, media and ribbon before using in production.

Generate printer settings in three steps

Enter label and printer values

Set width, length, darkness, speed, orientation and media type for your Zebra printer.

Generate setup commands

The tool outputs common ZPL and SGD commands that can be sent to controlled devices.

Test on real hardware

Print a configuration label or test media before rolling settings into production workflows.

Często zadawane pytania

~SD controls print darkness. Higher values print darker, but too much darkness can reduce barcode quality.

^PW sets print width in dots. Match it to your label width and printer DPI.

No. This page generates commands only. Copy them into your trusted printing workflow or device management tool.

The output includes a common SGD print-method command alongside ZPL commands where useful.