Zebra 프린터 설정 생성기
일반적인 Zebra 프린터 설정 작업을 위한 ZPL 및 SGD 조각을 만듭니다. 실제 장치에서 테스트하기 전에 너비, 길이, 농도, 속도, 방향, 미디어 명령을 생성하세요.
^PW^LL~SD^PR
프린터 설정
ZPL / SGDSend settings only to printers you control. Test on non-production media first because darkness, speed and calibration affect real labels.
생성된 명령
Device setupProduction safety note
These commands may change physical printer behavior. Verify values against your printer model, media and ribbon before using in production.
Generate printer settings in three steps
Enter label and printer values
Set width, length, darkness, speed, orientation and media type for your Zebra printer.
Generate setup commands
The tool outputs common ZPL and SGD commands that can be sent to controlled devices.
Test on real hardware
Print a configuration label or test media before rolling settings into production workflows.
자주 묻는 질문
~SD controls print darkness. Higher values print darker, but too much darkness can reduce barcode quality.
^PW sets print width in dots. Match it to your label width and printer DPI.
No. This page generates commands only. Copy them into your trusted printing workflow or device management tool.
The output includes a common SGD print-method command alongside ZPL commands where useful.